+86-755-81792269
About Us
Professionalism, efficiency, innovation and excellence
All Categories>
SMC Mould】Talk about the installation procedure of FRP molds.
Release time:
2023-07-01
Today, the mold of SMC mold consultant and customers briefly say about the installation of FRP mold operating steps of the problem, the specific program content is as follows:
1, first install the bottom: according to the tank veneer on the printed number and description, arrangement, connect the bottom plate of the tank, while adding sealing tape between the two sheets of veneer, with φ10 bolts to connect. Make the bottom plate sealed, bolt force should be uniform force, each bolt force 3-4 times, shall not force too hard, otherwise due to the force is not uniform and caused by the phenomenon of cracking plate.
2、Connect the base plate and channel steel with fixed angle iron, so that the FRP water tank box is fixed on the channel steel base.
3、Installation of each state: According to the printing number and description on the water tank veneer, find out the state number of each layer of the water tank body and separate them in advance, and assemble the body with bolts. Stand up the water tank board, find the right, make the board and the bottom state form 90 degree angle, and add the sealing tape, tighten the bolt.
4、Installation of the inner rebar: the inner rebar according to the size of the water tank, find the number and length of the rebar. Measure the fastening part of the ribbing with the ribbing board, draw the seal, punch the eye, on the ribbing, fastening, so that the ribbing is flat and the water tank box to maintain a balance. If there is a large error between the box and the rebar, you can adjust the size of the error by adjusting the degree of bolt fastening, until the error is adjusted to a smaller.
5, the installation of the cover is better: the top of the water tank cover installation, to evenly tighten the bolts, not too much force or too small. After adjusting the fasteners of the water tank, according to the drawings of the opening position, open the mouth of each water pipe, on the flange in order to dock the valve. 6, after the installation of the water tank, a unified inspection, adjustment, water test 24 hours without leakage fiberglass water tank is qualified. Summarize: any work should be conscientious, diligent, careful.
Of course, the installation of glass fiber reinforced plastic water tank is also so, to be careful, conscientious, step by step, step by step to win each step to do a good job, in order to achieve the glass fiber reinforced plastic water tank drip water does not seepage.
RELATED INFORMATION
2023-07-01
Follow us.